The plan
Inchworms look like a harmless warm-up until the athlete reaches the floor. Then the movement gets honest. Tight hamstrings, soft shoulders, and a loose brace all show up before the workout has even started.
That is why the drill earns its place in CrossFit. It is not just a way to get warm. A good inchworm teaches the athlete to move from a standing hinge into a plank without dumping the ribs, rushing the hands, or turning the low back into the main stabilizer.
- Walk the hands out under control and stop in a real plank, not a sagging push-up setup.
- Keep the knees soft if hamstring tension forces the back to round hard.
- Use inchworms before burpees, push-ups, handstand work, crawling, and core-heavy WODs.
What a clean inchworm looks like
Start standing tall, then hinge forward and place the hands on the floor. The athlete walks the hands away from the feet until the body reaches a strong plank. From there, the feet step or inch toward the hands, and the athlete stands back up without rushing the reset.
The clean version is quiet. The hands do not slap the floor. The hips do not collapse as soon as the athlete reaches plank. If the movement turns into a race across the gym, the drill stops teaching anything useful.

The brace is the part athletes skip
Most bad inchworms fall apart in the same place. The athlete reaches plank, the ribs flare, the hips drop, and the shoulders slide behind the hands. It still looks like movement, but the position no longer matches what the next part of training needs.
Coach the plank the same way you would during dead bug bracing work or hollow rock practice. Ribs down, glutes lightly squeezed, hands pressing the floor away. That position carries into plank shoulder taps, burpees, push-ups, and wall-facing gymnastics prep.
| Fault | What you see | Fix |
|---|---|---|
| Hips sag in plank | The low back takes over before the feet move | Shorten the walkout and brace before each step |
| Knees lock too hard | The back rounds just to reach the floor | Soften the knees and keep the hinge under control |
| Hands rush forward | The athlete lands in a sloppy plank | Take smaller hand steps and pause at full reach |
| Shoulders drift back | The plank looks passive and loose | Stack shoulders over hands and push the floor away |
Where inchworms help in CrossFit
Inchworms fit best before sessions that ask the trunk and shoulders to stay organized. They make sense before burpees, bear crawls, push-ups, wall walks, handstand holds, and workouts with a lot of floor-to-standing transitions.
The drill pairs well with bear crawl practice when the workout includes crawling or with ring push-up control before pressing. If the day includes a lot of burpees, inchworms can reveal whether the athlete is ready to move fast from the floor without losing the midline on every rep.
The video below is useful because it keeps the movement simple: hands walk out, body reaches a controlled plank, then the feet move in. Watch the brace and shoulder position more than the speed.
How to scale the drill without turning it into nothing
The simplest scale is a shorter walkout. Stop before the plank breaks, hold for a second, then walk back. That is better than forcing a full-length rep with a sagging hip and a painful hamstring stretch.
Athletes with limited hamstring range can bend the knees. That does not ruin the drill. It lets them reach the floor while keeping the spine calmer. Over time, the legs can straighten more, but only if the brace and shoulder position stay intact.
How many reps to use
Use a small dose. Five to eight slow reps is enough for most warm-ups. If inchworms come before a workout with high-volume pressing or burpees, the goal is to wake up the pattern, not spend shoulder stamina before the clock starts.
For a stronger warm-up, add a controlled push-up only if the athlete can keep the plank honest. If the push-up turns every rep into a sag, remove it and keep the inchworm clean.
What to test in the next warm-up
Before the next WOD with floor work, ask for three inchworms where the athlete can pause in plank for two seconds without the ribs popping up or the hips dropping. That pause tells you more than ten rushed reps.
If the pause looks solid, add speed later. If it does not, keep the reps shorter and cleaner. The warm-up should expose the leak while there is still time to fix it.
